Hello & Happy Winter! I am here to try to make your life easier, and teach you my dog walkers hack to putting on PAWZ DOG BOOTS. Here is a video, thanks to my demo dog Sadie, but I also tried to write out instructions with pics (thx Frankie) Step 1: Get the right size for your dog. A lot of people buy too large, because they are hard to put on so they size up - but this will lead to boots falling off. If your dogs are like mine, you may need one size for their front paws, and a smaller size for the back paws. Step 2: Have the boots ready, and your dog in front of you. Step 3: Take your index & middle finger from one hand, and your index/middle/ring finger from your other hand and shove em on in the boot & streeeeetch! Step 4: Using the index finger from the 2-finger hand, and guide the paw toward the boot. Take the paw and press it against the inner top part of the balloon (the part of the balloon closer to your face). Your goal is to make the balloon hole much wider vertically (with our fingers we just make it wide horizontally). Your goal at this point isn't to get the boot on. Step 5: With the middle finger from the 3-finger hand, press on the back of the paw and guide the paw into that nice big hole you've created. Step 6: Remove your fingers by lifting upward. Step 7: Marvel at how wonderful you & your dog are. Step 8:
PRACTICE. I have done this THOUSANDS of times, you will find the right angle to press the paw onto the balloon and the right finger manoeuvre to get the paw into the PAWZ.
0 Comments
|